Connect the AC1000M Router to Your Computer

To set up your router for the first time, please connect the router to your desktop or laptop computer as shown in the following diagram. Your broadband Internet access will from a Zhone DSL modem device. Turn on the power switch on the back of the router.

2. After the hardware connections have been completed, check the status of the LED Indicators using the following table:

LED Indicator	Status	Description
POWER	On (Green)	The router is powered on and running normally
POWER	Off	The router is powered off
WAN	On (Green)	The port is connected
	Off	The port is disconnected
	Blinking(Green)	Data is transmitting
LAN 1/2/3/4	On (Green)	The port is connected
	Off	The port is disconnected
	Blinking(Green)	Data is transmitting
2.4G	On (Green)	Wireless access point is ready
2.4G	Blinking(Green)	Wireless traffic active
5G	On (Green)	Wireless access point is ready
5G	Blinking(Green)	Wireless traffic active
USB	On (Green)	USB device is connected
USB	Off	No USB device is connected

Safety Notice

The device should be placed on a flat horizontal surface or secured safely to a wall.
• Operate equipment away from heat sources.
• Provide good air ventilation.
• Keep away from water and damp areas.
• Disconnect power from the device during severe thunderstorms.
• Use only the included AC power adapter.
• Keep router at least 20 cm away from people to reduce exposure to radio frequency emissions.

Hooking up a Readynet Router to State College Internet.

Connect the AC1000M Router to Your Computer

0 Comments